1 7
Hundreds: Press the
button
Tens: Press the
button
Units: Press the
button
MONITOR PROGRAMMING
Option 2: From the Monitor
1.
Enter configuration
mode: Press the
button for 2 seconds. The LED blinks once per second
and a confirmation tone is heard.
2.
Set the monitor in programming mode
: With the monitor connected, press the programming button
for 1 second.
At this point, the call number currently programmed is indicated by means of high-pitched tones. First,
the Hundreds, then Tens, and finally the Units.
To separate each unit, the LED comes on and a lower tone is heard.
3. Program the call number:
Every time the button corresponding to hundreds, tens or units is
pressed, the figure increases by one.
4.
Exit programming:
Press the programming button or wait for 30 seconds without pressing any buttons.
When you exit prgramming mode, the number indicated is stored. If it is correct (between 1 and
199), a confirmation tone is heard. If it is not correct, an error tone is heard.
If 9 is reached and the button is pressed
again, an error tone is heard. The next
button pressed starts off from number1.
Current no:12
0
moc
1
beep
moc
2
beep
beep
moc
1
2
3
4
(5 sec.)
To program the monitors from the MDS Digital plate/guard unit, please consult the advanced manual for
the VDS decoder, ref. 2409 (code 97651). Available at www.fermax.com
Option 1: From Plate + Monitor
Summary of Contents for MS-BOX
Page 13: ...13 ENGLISH...
Page 23: ...23...
