MOUNTING ACCESSORIES
Fig. B
Always remove the battery before starting work.
FITTING AND REMOVING DRILL CUTTERS
In addition to drill cutters, the tool can also accommo-
date screwdriver bits with a hexagonal shaft.
•
Loosen the drill chuck (4) by rotating the hand-grip
(9).
•
Insert the shaft of the drill cutter into the chuck.
•
Tighten the drill chuck so that the drill cutter is firmly
clamped.
•
Rotate the drill chuck in the opposite direction when
you wish to change the cutter.
CONNECTING AND REMOVING THE
BATTERY
Fig. C
Ensure that the exterior of the battery block or tool
is clean and dry before connecting the charger.
•
Ensure that the direction reversing switch (6 Fig. A) is
in the central position in order to prevent the
appliance from being switched on unexpectedly.
•
Insert the battery (5) into the base of the appliance, as
shown on the illustration. Push the battery until it
latches in.
•
Press the locking buttons (10) on both sides before
removing the battery, and disengage the battery from
the base of the appliance.
OPERATION
Fig. D
Always follow the safety notes and the relevant
safety code.
Hold the appliance firmly and press the drill cutter ste-
adily onto the workpiece. Do not overload the appliance.
Only use drill cutters with no visible wear. Worn drill
cutters will have a bad effect on the functioning of the
appliance.
ADJUSTING THE SPEED
The appliance has two drill speeds.
•
For slow drilling or for driving or removing screws,
set the speed selection switch (2) to '1'.
•
For fast drilling set the speed selection switch to '2'.
NEVER SWITCH OVER WHEN THE
MOTOR IS RUNNING!!!
ADJUSTING THE TORQUE
Fig. E
The appliance has 16 different torque settings with which
to set the power for driving and removing screws.
•
Set the torque adjustment ring (3) to the desired
position.
The available torque settings are indicated on the
adjustment ring by the numbers 1 to 8 and by dots
between the figures to define intermediate settings
(16 in total).
•
You should preferably choose as low a setting as
possible when using the screwdriver. Select a higher
setting if the motor slips.
DRIVING AND REMOVING SCREWS
•
Set the direction reversing switch (6) to position 'R'
in order to drive screws.
•
Set the direction reversing switch to position 'L' in
order to remove screws.
DRILLING
•
Rotate the torque adjustment ring (3) to the drilling
position.
Ensure that the direction reversing switch (6) is
always set to 'R' during drilling.
SWITCHING THE DEVICE ON AND OFF
Fig. A
•
Depress the on/off switch (1). It regulates the speed
of the appliance by transmitting power to the switch.
•
Release the on/off switch (1) to halt the drill chuck
immediately which will no longer run on.
•
Move the direction reversing switch (6) to the centre
in order to lock the appliance in its disabled state.
Only lay down the appliance when it has stopped running
completely. Do not place it on a dusty surface as particles
of dust could get into the mechanism.
Ferm
5
8
Ferm
