Ferm
89
Fjern fastsiddende snavs med en blød klud fugtet med søbevand. Brug ikke opløsningsmidler,
som f.eks. benzin, alkohol, ammoniak, osv. Disse midler kan beskadige plastikdelene.
Smøring
Maskinen behøver ingen smøring.
Fejl
Skulle der f.eks. opstå problemer efter brug af en del, skal du sætte dig i forbindelse med den
adresse, der er angivet på garantikortet. I bagerste del af denne brugsanvisning findes en
udførlig oversigt over de dele, der kan bestilles.
Miljø
For at forhindre transportskader, leveres maskinen i en solid emballage. Emballagen består
hovedsageligt af genbrugsmateriale. Udnyt også muligheden for at genbruge emballagen.
Defekte og/eller bortskaffede elektriske eller elektroniske apparater skal afleveres
på de relevante genbrugsstationer.
Garanti
Læs garantibetingelserne på det vedlagte garantikort. Slid af skruebits dækkes ikke af
garantien.
GB
D
NL
F
E
P
I
S
FIN
N
DK
08
Ferm
Drilling
Fig. D
•
Turn the torque adjusting ring (5) to the drilling position.
Ensure that the direction of rotation switch (1) is always set to 'R' when drilling. “R”-
to the right. “L”- to the left.
Percussion drilling
Fig. D
Insert an undamaged drill bit into the clamping chuck. For drilling in soft materials, such as
plastic or wood, use a metal drill bit and turn the changeover switch (6) to the right until the
indicating mark points to 'Drill bit' (drilling). For percussion drilling in hard materials, such as
stone and concrete, turn the changeover switch to the left until the indicator mark points to
'Hammer' (percussion drilling).
Regularly check the clamping chuck for damage. If necessary, use coolant when
drilling. When drilling in walls, bear in mind that electrical lines and water pipes may
be located inside the walls.
Switching ON and OFF
Fig. A
•
Press the ON/OFF switch (2). You can regulate the speed of the device by means of power
transmission to the switch.
•
When you release the ON/OFF switch (2), the drill chuck stops immediately and does not
continue to run.
•
Turn the direction of rotation switch (1) to the center in order to disable the device in the
switched off state. Do not lay the device down until the motor comes to a complete stop. Do
not lay the machine down in dusty areas. Dust or grime can enter through the air ventilation
openings.
Charging the battery
Fig. E
The battery charger is only suitable for charging type FCDB-2400 batteries.
•
Insert the battery (Fig. A-3) into the battery charger (9) as shown in the drawing. When
doing so, note the + and - polarisation markings.
•
Plug the battery charger's power plug into the power supply outlet. The quick charge lamp
(10) illuminates.
•
Once the green lamp (11) illuminates indicating conservation charge, charging has
completed.
The battery is ready for use
Only use the battery charger in a dry environment with a temperature of between 10 °C and 40
°C. The battery for your power drill is not charged at the factory. Before the first use, 1 to 2 hours
are required in order to reach a full charge. The ultimate capacity of the battery is reached after
4 to 5 charging/discharging cycles.
GB
D
NL
F
E
P
I
S
FIN
N
DK
