Care and Maintenance
When cleaning your toilet, wash it with mild,
soapy water, rinse thoroughly with clear
water and dry with a soft cloth.
Avoid detergents, disinfectants or cleaning
products in aerosol cans.
NEVER
use abrasive scouring powders or
abrasive pads on your toilet seat. Some
bathroom chemicals and cosmetics may
damage the seat’s finish.
CAuTION:
Product is Fragile. To avoid break-
age and possible injury handle with care!
DO NOT
use abrasive powder or liquid
cleaners which can damage the product
surface. Over tightening of the lock nut
or coupling nut could result in breakage
and flooding.
Problem
Reason
Solution
Fill Valve will not fill.
Fill Valve will not fill?
Float valve is stuck?
Drain Guards are stuck?
Turn on water supply at angle stop valve.
Loosen fill valve nut and turn fill valve away from back of tank.
Clean drain guard of debris.
Fill valve will not
shut off.
Water supply continues to run?
Float is stuck?
Flapper is stuck open?
Turn off water and clean the inside fill valve.
Loosen fill valve nut and turn fill valve away from back of tank.
Check chain length and flush valve seat.
Leakage.
Fill valve nut is loose?
Flapper is not seated properly?
Flapper is not seated properly?
Check the flush valve is tightened into place.
Check hex nut on fill valve to assure it is tight.
Clean flush valve seat, replace flapper if necessary.
Poor Flush.
Water level is not set to
proper height?
Low water pressure?
Obstruction in bowl?
Short Flush?
Adjust the water level set screw to assure water is at the
maximum level line.
Make sure the minimum water pressure is above 35 PSI.
Plunger the bowl and clean the drain line as necessary.
Adjust the chain length of the flapper.
InstallatIon InstructIons
skIrted het two pIece toIlet
!
WARNING
DO NOT uSE IN-TANK
TOILET BOWL CLEANERS
CONTAINING BLEACH
OR CHLORINE!
1. Result in damage to tank components and
may cause flooding and property damage.
2. Void PROFLO Fixtures Limited Warranty.
NO
BLE
ACH DROP-
IN
S
N
O
BLEA
CH DRO
P-
IN
S
DO NOT
use the cone washer with a plastic
supply line.
DO NOT
use pipe dope or other silicon based
materials to tighten supply coupling nut.
NOTE:
All trouble shooting should be done by a
qualified plumbing technician.
Install Tank Lid and Seat
1. Gently set the lid on the toilet tank.
2. Install the toilet seat to the specifications of
the seat supplier or manufacture.
Tank Replacement Part Information
The inside back of your tank is stamped with
replacement part information. Please record
and maintain this record for future maintenance
and reliable service of your new toilet.
Fill valve body
Float Cup
Rubber Seal
Adjustable
Rod
Triangle Gasket
Plastic Seal
Hexagon Seal
