Ferax 16232-0105, Manual, Page: 36 / 104

Ferax 36
GB
• Always remove the plug from the mains socket before carrying out any work on the
machine.
• Do not carry the machine by the cable.
• Incorrect handling may damage the machine. Therefore always comply with the
following instructions.
• Use only sharp saw blades in perfect condition; replace cracked, distorted or blunt
saw blades immediately.
• Machine should only be switched on with blade installed
• Select tools, stroke rate and pendulum actions according to material, Take care to
maintain a constant reed rate.
• Do not attempt to stop the saw blade with lateral pressure after switching off.
• Only use genuine accessories.
• Always use the correct supply voltage. The voltage specifications on the rating plate
must correspond with the mains voltage. Equipment marked with 230 V can also be
connected to 220-240 V.
IMMeDIATeLY sWITCH OFF THe MACHINe WHeN:
• Excessive sparking of the carbon brushes and verticiliosis in the collector.
• Interruption in the mains plug, mains lead or mains lead damage.
• Defect switch.
• Smoke or stench of scorched insulation.
eLeCTRICAL sAFeTY
Alwayscheckthatthepowersupplycorrespondstothevoltageontherating
plate.
YourmachineisdoubleinsulatedinaccordancewithEN60745;thereforeno
earthwireisrequired.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new
ones. It is dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
2
. When using a cable reel always unwind the reel
completely.
3. OPeRATION
Beforeassembly,alwaysswitchoffthemachineandremovethemainsplugfrom
the mains
Mounting and removing the saw blade (fig. B)
Mounting
• Open the collar (3) by turning it counterclockwise.