Effective: January 2023
4
F-05-50
Figure 2. Wired to 120VAC Gas Control
LED DESIGNATIONS
TROUBLESHOOTING
Disposal
Do not discard the connectivity module in the trash, recycle per
local guidance.
Wi-Fi Network Change
If the connectivity module must be connected to a new network
or the network password changes, the module will need be re-
provisioned again. This can be accomplished by pressing the
Reset button on the connectibity module. Alternatively, on
power up, if the module cannot connect to the router there is a
brief period where the provisioning mode is open.
Internal Control Failure
If the connectivity module detects a software or hardware error,
all outputs are turned off. If this condition persists after an
attempt to restart, then the control must be replaced.
LED
Condition/Mode
LED 1 Flashing Red
Connecting to Local Router
LED 1 Solid Red
Provisioned, No Internet
LED 2 Flashing Green Provisioning Mode
LED 2 Solid Green
Connected to Internet
LED 3 Flashing Red
Communication Fault with Control
LED 4 Solid Green
Communicating with Control
No LEDs
No Power / Hardware Fault
WARNING
Risk of Explosion or Fire
The 05-50 cannot be service by the user, this can
lead to risk of fire and voids warranty. If controls
faults are detected the 05-50 must only be
replaced by a qualified service personnel.
Do not use aluminum wire, this can also lead to
risk of fire.
WARNING
This product can expose you to chemicals
including Lead and Nickel which are know to the
State of California to cause Cancer and Birth
defects or other Reproductive Harm. For more
Troubleshooting Guide
Symptom
Recommended Actions
1.Dead
(No LED’s after power up.)
A. Miswired
B. Fuse/circuit breaker fault
C. No voltage at PWR
D. Faulty control
2. No Internet
(LED1 Solid Red)
A. Restart Router
B. Restart Modem
C. Reposition Antenna
