Intelligent Memory Circuit
The light memorizes the last selected brightness level on General mode. When turned on again
the previously used brightness level will be recalled.
Intelligent Overheat Protection
The light will accumulate a lot of heat when used on Turbo output level for extended periods.
When a temperature of 65°C or above is reached, the light will automatically step down by a few
lumens to reduce temperature. When the temperature is reduced, the output will gradually
return to Turbo output level.
④Battery Level Indication
There are four LED’s in the light tail. Single clicking the round switch on the tail will indicate
remaining battery level for 3 seconds:
The more LED’s light up, the higher the battery level.
Four LED’s on: more than 80%;
Only one LED on: more than 20%
One LED flashing: less than 20%
Low-voltage Warning
When the voltage level drops below the preset level, the flashlight is programmed to downshift
to a lower brightness level until Eco output is reached. When this happens in Eco output mode,
the flashlight blinks three times every five minutes to remind you to replace the battery. To
ensure normal use, the flashlight will only turn off once the battery over-discharging protection
activates.
⑤Charging
First plug the USB terminal of the charging cable into an electrical outlet, then connect the Micro
USB terminal of the charging cable to the light. The LED indicators will flash in sequence while
charging, and will turn to constant on when fully charged. The normal charging time is
approximately 4 hours.
