Fenix SM2000, Operation Manual

Page: 40 / 65

FENIX IMVICO SM2000 OPERATION MANUAL
40/65
ESC c 3 n
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0
≤
n
≤
255
[Description] Selects the paper sensor(s) to output paper end signals
Each bit of
n is used as follows:
Bit OFF / ON Hex Function
OFF 00 Paper roll near-end sensor disabled 0
ON 01 Paper roll near-end sensor enabled
OFF 00 Paper roll near-end sensor disabled 1
ON 02 Paper roll near-end sensor enabled
OFF 00 Paper roll end sensor disabled 2
ON 04 Paper roll end sensor enabled
OFF 00 Paper roll end sensor disabled 3
ON 08 Paper roll end sensor enabled
4-7 - - Undefined
[Notes]
•
The command is available only with a parallel interface and is ignored with a serial interface.
•
It is possible to select multiple sensors to output signals. Then, if any of the sensors detects
a paper end, the paper end signal is output.
•
Sensor is switched when executing this command. The paper end signal switching be
delayed depending on the receive buffer state.
•
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals
•
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor
outputting paper-end signals.
•
When all the sensors are disabled, the paper end signal always outputs a paper present
status.
[Default] n = 12
ESC c 4 n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0
≤
n
≤
255
[Description] Selects the paper sensor(s) used to stop printing when a paper-end is detected, using n
as follows:
Bit OFF / ON Hex Decimal Function
OFF 00 0 Paper roll near end sensor disabled. 0
ON 01 1 Paper roll near end sensor enabled.
OFF 00 0 Paper roll near end sensor disabled. 1
ON 02 2 Paper roll near end sensor enabled.
2-7 - - - Undefined.
[Notes]
•
When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.
•
When the paper roll sensor detects a paper-end, the printer goes offline after printing stops.
•
When either bit 0 or 1 is on, the printer selects the paper roll near-end sensor for the paper
sensor to stop printing.
[Default] n = 0