Fender CYBER-TWIN SE, Manual

Page: 8 / 36

w ww ww w. .f f e e n n d d e e r r. .c co om m
✧
w ww ww w. . m m r r g g e e a a r r h h e e a a d d . .n ne et t
This page introduces key concepts for the basic operation of your
Cyber–Twin SE™. The following pages provide an overview of each item
on the front and rear panels.
The D
ISPLAY
shows vital information and menus for the Cyber-Twin ® SE.
The D
ATA
W
HEEL
works dynamically with the display giving you full control
over preset selection, effect parameters and system configuration. The
display also responds to the use of panel knobs or buttons providing
useful information. You can enter different M
ODES
to edit amplifier designs,
effects and system utilities; each mode determines the functions of the
display and data wheel.
P
LAY
M
ODE
is active whenever the Cyber-Twin ® SE amplifier is first
switched on. After booting up, the display will show information about the
current preset. The first line displays the preset location (bank/number)
and name. The second line displays the type of tone stack controls (treble,
middle, bass), tone stack location (pre/post distortion) and the active
effect. In play mode, the data wheel selects presets.
There are three banks of P
RESETS
. The F
ENDER
C
USTOM
S
HOP
(C00-C99)
and Y
OUR
A
MP
C
OLLECTION
(A00-A49) are permanent presets. The
P
LAYER
’
S
L
OUNGE
(P00-P99) presets are rewritable for you to save your own
amp and effect designs.
The Cyber-Twin ® SE is instantly reconfigured to the settings saved within
a selected preset. The 8
MOTORIZED
knobs on the Cyber-Twin
®
SE
automatically adjust to the preset settings. You can safely interrupt knob
rotation anytime by manually stopping it. Note that the display will
temporarily indicate knob position when turned manually.
Changes you make to amplifier settings (volume, tone, effects, etc.) will be
lost upon selecting a different preset or turning the amplifier off, unless you
save them. S
AVE
simply by pressing SAVE, selecting a Player’s Lounge
preset to overwrite and pressing SAVE again. The S
AVE
LED blinks
as a reminder to save settings once a change is made. NOTE: M
EMORY
P
ROTECTION
must be disabled before you can save! (see page 24).
A
MP
E
DIT
M
ODE
, FX E
DIT
M
ODE
and U
TILITY
M
ODE
are activated by pressing
the corresponding buttons to the right of the display. Use these modes for
modifying amp design, selecting and editing effects and for system
management. T
UNER
M
ODE
is activated using the TUNER button; use it to
tune your guitar. P
LAY
M
ODE
is reactivated by pressing EXIT. Use it to play
guitar!
Two F
OOTSWITCHES
are supplied with your Cyber-Twin
®
SE. Connect them
to the appropriate rear panel jacks to enable remote selection of your
Quick Access buttons and Reverb/Effects bypass.
Each preset contains a complete set
of amplifier and effects settings.
w ww ww w. .f f e e n n d d e e r r. .c co om m
✧
w ww ww w. . m m r r g g e e a a r r h h e e a a d d . .n ne et t
8
Front Panel Overview
1
1
✧
✧
Over
Over
view
view