Page 4
Lotus DX
cord management
cord management
set-up continued
step 2a
Route the keyboard and mouse cords through the opening in the keyboard platform. Be sure to anchor
the cords with the clip on the underside of the platform. Failure to follow these instructions may result in
equipment damage or personal injury.
Ensure the workstation is at the highest position. Follow all cord routing instructions to ensure cables are
not pinched by the support bars. Make sure the cables are long enough to accommodate the full range of
motion (17”/432mm).
step 1
Setup the charging stations by connecting the power cord to the power supply and the power supply to
the rear USB hub port 2. Plug the power cord into the nearest outlet. In order to use USB ports 3 and 4
for your mouse and keyboard, you will need to plug the provided Type B/USB cord into port 1 and the USB
end into your computer, docking station or monitor*.
*Monitor needs to be connected to computer via additional Type B/USB cord (not included).
STEP 2
Place your monitor, keyboard and mouse on the
workstation. Use the enclosed Velcro to secure
the monitor(s) to the workstation. Leave the
monitor cover plate in place unless using the
Lotus monitor arm kit.
STEP 3
Using both hands, push down slightly and engage
both levers to raise the workstation to the highest
position.
