2
Feed paper/card
straight into paper
entry and release
When finished
shredding set to
OFF ( )
PAPER/CARD
Plug in and put
disconnect power
switch in ON (I) position
Continuous operation:
Up to 8 minutes maximum
NOTE:
Shredder runs briefly after each pass to clear entry. Continuous
operation beyond 8 minutes will trigger 20-minute cool down period.
CAPABILITIES
BASIC SHREDDING OPERATION
ENGLISH
Model W-61Cb
Will shred:
Paper, plastic credit cards, staples and small paper clips
Will not shred:
Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Cross-Cut ......................................................................................................4mm x 50mm
Maximum:
Sheets per pass ........................................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V/50/60 Hz, 1.4Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 200 sheets;
5 credit cards.
10 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
t 0QFSBUJPONBJOUFOBODFBOETFSWJDFSFRVJSFNFOUTBSFDPWFSFEJOUIFJOTUSVDUJPO
manual. Read the entire instruction manual before operating shredders.
t ,FFQBXBZGSPNDIJMESFOBOEQFUT,FFQIBOETBXBZGSPNQBQFSFOUSZ"MXBZT
set to off or unplug when not in use.
t ,FFQGPSFJHOPCKFDUToHMPWFTKFXFMSZDMPUIJOHIBJSFUDoBXBZGSPNTISFEEFS
PQFOJOHT*GPCKFDUFOUFSTUPQPQFOJOHTXJUDIUP3FWFSTF
) to back out
PCKFDU
t
DO NOT use aerosol products, petroleum based or aerosol lubricants on or near
shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON SHREDDER. Vapors from
QSPQFMMBOUTBOEQFUSPMFVNCBTFEMVCSJDBOUTNBZDPNCVTUDBVTJOHTFSJPVTJOKVSZ
t %POPUVTFJGEBNBHFEPSEFGFDUJWF%POPUEJTBTTFNCMFTISFEEFS%POPUQMBDF
near or over heat source or water.
t 5IJTTISFEEFSIBTB%JTDPOOFDU1PXFS4XJUDI 'UIBUNVTUCFJOUIF0/ *QPTJUJPOUP
operate shredder. In case of emergency, move switch to OFF (O) position. This action
will stop shredder immediately.
t "WPJEUPVDIJOHFYQPTFEDVUUJOHCMBEFTVOEFSTISFEEFSIFBE
t 4ISFEEFSNVTUCFQMVHHFEJOUPBQSPQFSMZHSPVOEFEXBMMPVUMFUPSTPDLFUPGUIF
voltage and amperage designated on the label. The grounded outlet or socket must be
JOTUBMMFEOFBSUIFFRVJQNFOUBOEFBTJMZBDDFTTJCMF&OFSHZ
converters, transformers, or
extension cords should not be used with this product.
t '*3&)";"3%o%P/05TISFEHSFFUJOHDBSETXJUITPVOEDIJQTPSCBUUFSJFT
t 'PSJOEPPSVTFPOMZ
t 6OQMVHTISFEEFSCFGPSFDMFBOJOHPSTFSWJDJOH
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
2
1
3
4
KEY
H. Control Switch and Indicator lights
1.
Reverse
2.
OFF
3. Auto On (blue)
4.
SafeSense
®
indicator (yellow)
5. Overheat (red)
6. Door Open/Bin Full (red)
7. Remove Paper (red)
A. SafeSense
®
Technology
B. Paper entry
C. Pull-out Bin
D. Window
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
Set to Auto-On ( )
BASIC SET UP
CASTER INSTALLATION
F
.
H.
A.
G.
B.
C.
D.
E.
1
2
3
4