FELLER ENGINEERING SS 242, Manual

Page: 21 / 24

the appliance to complete the process. During this process, the appli-
ance occasionally produces pumping and clicking sounds.
2. When the Auto Calc Clean process is completed, the descaling indicator
goes off. The appliance will enter to the normal operation mode auto-
matically.
3.
Remove the water tank and empty out the drainage.
4.
Refill the water tank and replace it in position. The Auto Calc Clean pro-
cess is now finished and you can start ironing when the steam light is
on continuously.
Note
: If you do not empty out the drainage in the collecting chamber of
water tank, the tank will overflow during the next Auto Calc Clean process.
Note : During the Auto Calc Clean process, you can press and hold the Steam
rate control button (for decreasing steam) for about 10 seconds to cancel
this process.
MANUAL CALC CLEAN PROCESS
The Auto Calc Clean system keeps the appliance sufficiently clean. However,
you can also perform the Calc Clean process manually for additional clean-
ing.
1. Fill the water tank to the maximum level.
2.
Press the power switch and the steam rate control button (for increasing
steam) with one hand, and plug the power outlet with the other hand,
one beep sound will be heard.
3.
Press the power switch again, the descaling indicator will flash, the Auto
Calc Clean process will begin.
4.
Follow steps 1-4 of the Auto Calc Clean process described above
5. Note: The manual Calc Clean process can only be activated if the ap-
pliance is sufficiently cold. If the appliance is too hot for the manual
Calc Clean process, the steam rate control button (for increasing steam)
flashes and the appliance continues to heat up for use.
9