NEW FOB SETUP & sync
Pairing is only necessary the first time you use the system and not
necessary before each boating trip. Pairing is the first-time-use
procedure of synchronizing your FOBs unique IDs with your HUB to
allow the two to connect wirelessly.
3
sec
3
sec
Press and hold
the button on
your HUB.
The HUB starts
flashing blue and
gives a sound
signal indicating
Pairing Mode.
Press and hold
the button on
your FOB
The HUB will give a
sound signal and a
green light to indicate
a successful pairing.
The HUB can store the ID of up to 20
unique FOBs at any given time. If pairing
more than 20 FOBs the system will start
overwriting the first stored FOB IDs. The
HUB will continue to remember the FOB
IDs even though the unit lose power.
Smart FOB memory
To use a particular FOB on multiple boats,
you need to repair the FOB for each time
the FOB is transferred to the new vessel.
The FOB only remember its last paired
HUB, this is to prevent it from connecting
to more than one HUB at the time.
One FOB, multiple boats
FOB MISSING - OVERRIDE
If you have lost your FOB or if it’s out of battery, you can always
override the system. Remember that when you override the
system you will NOT be protected in a man overboard situation.
In the unlikely event that the MOB+ Sys-
tem stops functioning. Unplug the xHUB
and plug the emergency cap into the
cable to be able to drive your boat. The
emergency cap is located on the cable
supplied with the MOB+ xHUB.
Emergency Cap
Override Mode automatically times out
after 8h and shuts down your engine(s)
to prevent engine start if the boat is
left unobserved. After time-out the
Override Mode can be reactivated as
shown above.
8h Time-Out
10
sec
No FOB available
Press and hold
the button on
your HUB for 10
seconds
Success!
You can now start
your engine(s)
