Felisatti DC10/14,4L2, Original Instruction Manual

Page: 7 / 67

7
3
Check before Use
1. The power source
• Observe correct main voltage. The voltage
of power source must agree with the voltage
speciied in the name plate.
• Make sure the rated voltage in the electric drill
and the battery are the same. When the rated
voltage of the battery is higher than that of the
electric drill, the motor can be damaged by ire.
2. Attachment of the battery
Make sure the battery is attached correctly before
you use the electric tool.
If drill stalls, it is usually because it is
being overloaded or improperly used.
Release trigger immediately. Do not
click trigger on and off in an attempt to start
a stalled drill.
Make sure the battery is attached in the body of
the tool tightly before you start operation.
When the battery is not attached tightly, it may be
fallen during the operation and cause an injury in
the top of your foot.
3. Polarity of the battery
When the polarity of the battery is not correct,
it may cause the trouble of the switch. Also, the
reversal of the rotating direction can bring a
dangerous situation.
4. Trial run
Before starting the work, wear protection (goggles,
safety helmet, ear plugs, protective gloves) and
run the tool in the direction avoiding other persons
to see if the tool is operated normally.
4
Speciications and List of
Contents
1. Speciications
Model
DC10/14,4L2
Tool
Rated voltage, V 14.4
No load Sp.
[/min]
1st gear 0-450
2nd gear 0-1450
Maximum
capacity
[Ø mm]
Steel
10
Wood
20
Wood screw
10
Chuck capacity [mm] 0.8-10
Weight, according to
EPTA procedure 01/2003
[kg]
1.4
Battery
FL14415
Voltage, V 14.4
Capacity, h 1.5
Weight, [kg] 0.3
Battery
Charger
F144
Imput Voltage, V ~
220-240
Output Voltage, V 14.4/18
Charging Current, 3.0
Charging Time, min 35
Weight, kg 0.7
Saftey Class
II
2. List of Contents
Plastic case
1
Battery 2
Battery Charger 1
Instruction Manual
1
Hook 1