15
!
!
Dust Extractor
RL 250/RL 300
Delivery and assembly
4 Delivery and assembly
The dust extractor RL 250/RL 300 models are usually
delivered in a completely assembled state.
The dust extractor is shipped in a crate made of metal
sheets, and it is screwed down to the crate. Lift and if
necessary, transport the crate with appropriate hoisting
devices such as a stacker truck, crane or a lift truck.
Use the steering rollers to roll the dust extractor to its des-
tined location. There are two steering rollers with brake
blocks on the motor side to fix the position of the device
on a level floor surface.
Only set up and operate the duct extractor on an even
surface.
Insert a chip sack.
The container is then hermetically connected to the dust
extractor with a sealing clamp.
The dust extractor is assembled and ready to plug in. As-
semble the electrical connection as described in item 10.
To clean the filter, connect the dust extractor to the com-
pressed air supply with a 1/2 inch pneumatic hose.
Attention! The compressed air is free of oil and water!
Max. limit pressure: 7 bar
Operating pressure: 5 bar
Connect the duct extractor to the water-supply line or to
an appropriate water reservoir for the fire water supply.
Attention! The device may only be set up in a frost-free area!
Storage: keep dry and protect against unauthorised use!
