Felder FAT 300, User Manual

Page: 14 / 20

11
ca. 75 kg
2 x
!
!
!
Height adjustable FELDER working table
FAT 300
The machine is partly assembled when delivered on the
pallet
The machine is shipped mounted on a pallet. (4 x Secu-
ring bolt)
The machine can be transported/unloaded with a fork
carriage or a forklift truck or with a crane and hoisting
loop.
!
Securing bolt
Note:
The transportation width is well under 1000 mm. This makes it possible to transport the machine through
doorways.
To facilitate assembly, ensure the presence of a minimum of one additional people.
Individual installation instructions are found with the machine or the worktop surface.
Attention! Risk of material damage!
Transport the machine according to the enclosed transport and assembly instructions!
Fig. 4-1: Transport locking device
4.5 Transport
4.4 Storage
Keep items sealed in their packaging until they are
assembled/installed and be sure to observe the stacking and storage symbols on the outside of the packaging.
Store packed items only under the following conditions
• Do not store outdoors.
• Store in a dry and dust-free environment.
• Do not expose to aggressive substances.
• Protect from direct sunlight.
• Avoid subjecting the machine to shocks.
• Storage temperature: -10° to +50° C.
• Maximum humidity: 60 %.
• Avoid extreme temperature fluctuations (condensation
build-up).
• Apply a coat of oil to all bare machine parts (corrosi-
on protection).
• When storing for longer than 3 months, apply a coat
of oil to all bare machine parts (corrosion protection).
Regularly check the general condition of all parts and
the packaging. If necessary, refresh or re-apply the
coat of
anti-corrosive agent.
• If the machine is to be stored in a damp environment,
it must be sealed in air-tight packaging and protected
against corrosion (desiccant).
Transport, packaging and storage