FAQ • VIMBLE 2A
8) The Wi-Fi signal shows up but I am not able to connect to it. What should I do?
Temporarily turn off the Wi-Fi of the phone and make sure the camera is not
connected to any other devices (remote control for example)
‘Kill’ the Camera app completely from the background, or temporarily uninstall it;
Make sure the password is correct; pay attention to the capital & lower case and
do not input any space between the letters and numbers.
Clean up the WIFI connection cache. (trigger shutter pushing
down the roll control stick)
Take out the battery and install again. This way the WIFI connection will be
cleaned up too.
9) After restarting the gimbal, it will not connect with the camera automatically.
What should I do?
Try turning off the Wi-Fi of the camera for 30 seconds and turn on again;
Or reset the Wi-Fi connection of the gimbal and connect manually.
10) I cannot connect to the WIFI After updating the Bluetooth firmware. What
should I do?
Before updating: make sure to disconnect the gimbal and camera; During update:
make sure the network condition is good; After updating: clean up the Wi-Fi
connection first, and then connect again.
11) The gimbal is connecting with the camera via Wi-Fi but the GoPro is not
responsive when trying to control it.
Make sure the shutter function of the GoPro works fine:
--Take out the memory card from the GoPro, press the shutter button and see
if there is a message “no memory card” showing up on the screen. (if not, that
means the camera has a problem)
Also, test the camera functions and make sure the GoPro is not getting stuck.
--Take out the battery of the GoPro and install again, format the memory card
after rebooting the camera.