FeiYu Tech
Guilin Feiyu Electronic co.,Ltd http://www.feiyu-tech.com Email:[email protected]
4
necessary, loosen the screw(s) to properly fit the pieces.
Step 3: Welding (soldering) the frames to the bottom fuse plate
with the electronics.
To accomplish this you will need a small soldering iron aprox. 35w.
Plug in the soldering iron and while it is coming to temperature, gather your Rosen Core solder and
safety glasses.
With the soldering iron at temp. place the tip on the bottom fuse weld point, making sure that the tip
makes contact with both the frame and fuse weld points. Apply solder at this point, you will notice
that the solder will wik (Flow) smoothly and make a gusset. Make sure you don
’
t have a cold solder
joint. I needed, reheat the joint. Use caution as not to Over Heat the solder joints as this will cause
the metal to curl up and away from the contact point.
Follow this process for the remaining points.
Now remove the top Fuselage plate, this will gain you access to the weld points inside and between the
Frames.
Once inspected and sure that no cold solder joints are there. Connect a 3S Lipo Balance plug to the
plug on the bottom of the Fuselage.
You should have all the led
’
s lit and the bottom will light up White and will flash for a few seconds
Cross any two wire ,
change Motor rotation
welding
ESC
Fuselage with
Electronic
components
Magic cable
tie
through
square
groove
M3
×
25mm Pillar
