25
en
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off.
Check the power supply cable
and the plug for damage.
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
The
self-start lock
prevents the angle grinder
(see Table) from automatically restarting
again, even after a brief interruption of the
power supply, e. g., from a pulled power plug.
Angle grinders with electronics (see Table)
are equipped with overload and blocking pro-
tection. In case of overload or blocking of the
application tool, the power supply is inter-
rupted. in this case, switch the power tool off,
remove it from the workpiece and check the
application tool. Afterwards, switch the
power tool on again.
WSG8-115 (**)/WSG8-125 (**)/WSG11-125 (**)/WSG11-150 (**)/WSG12-125P (**)/
WSG17-125P (**)/WSG17-125PS (**)/ WSG17-150P (**)/WSG17-70 Inox (**) (figure 10)
.
Switching on:
Push the On/Off switch forward
(I)
.
Switching off:
Push the On/Off switch back
(
)
.
WARNING
WARNING
CAUTION
WSG12-125P (**)
WSG17-125PRT (**)
WSG17-125P (**)
WSG17-150PR (**)
WSG17-125PS (**)
WSG17-150PRT (**)
WSG17-150P (**)
WSG17-70 InoxR (**)
WSG17-70 Inox (**)
WSG17-70 InoxRT (**)
WSG17-125PR (**)
On/Off switch
Fig. 10
OBJ_BUCH-0000000224-001.book Page 25 Tuesday, July 28, 2015 11:31 AM
Summary of Contents for WSG11-150
Page 31: ...31 en D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 31 Tuesday July 28 2015 11 31 AM...
Page 61: ...61 fr D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 61 Tuesday July 28 2015 11 31 AM...
Page 91: ...91 es D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 91 Tuesday July 28 2015 11 31 AM...
