23
en
Mounting a grinding disc (figure 7)
when using a support flange (special
accessory).
The support flange may only be used with
grinding discs according to ANSI B7.1-2010
type 27, 28 and 29, and with a minimum off-
set of at least 4.6 mm (0.18 in) according to
DIN ISO 603-14.
Press the locking button only when the
motor is stopped.
Press the locking button completely through
and hold it in place. Loosen the clamping
flange with the pin-type face wrench.
Unscrew the clamping flange.
Replace the used-up grinding accessory
or insert a new one.
Pay attention that the grinding accessory
is properly centered between the sup-
port flange and the clamping flange.
Manually screw on the clamping flange again.
Press the locking button completely through
and hold it in place. Tighten the clamping
flange with the pin-type face wrench.
Note:
Pay attention to the mounting direction
of the clamping flange, which can vary
depending on the thickness of the grinding
disc.
Threaded flange
1.
3.
2.
4.
6 mm
1/4 in
6 mm
1/4 in
Clamping flange
4,6 mm
0,18 in
4,6 mm
0,18 in
Support flange
Fig. 7
OBJ_BUCH-0000000224-001.book Page 23 Tuesday, July 28, 2015 11:31 AM
Summary of Contents for WSG 17-125P
Page 31: ...31 en D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 31 Tuesday July 28 2015 11 31 AM...
Page 61: ...61 fr D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 61 Tuesday July 28 2015 11 31 AM...
Page 91: ...91 es D E F G A B C Fig 19 OBJ_BUCH 0000000224 001 book Page 91 Tuesday July 28 2015 11 31 AM...
