Fein WSG 17-125P Instruction Manual Download

Page: 8 / 91

Operate the power tool only off power sup-
plies whose voltage and frequency values
correspond with the values on the type plate
of the power tool.
If operating the power tool in a damp location,
it must be connected via a ground-fault cir-
cuit interrupter (GFCI).

Using special rubber

protective gloves and footwear increase your
own safety.

NOTE:

Such a device is also known as ground

fault circuit interrupter (GFCI) or earth leak-
age circuit breaker (ELCB).

Do not rivet or screw any name-plates or
signs onto the power tool.

If the insulation is

damaged, protection against an electric shock
will be ineffective. Adhesive labels are recom-
mended.

Always work with the auxiliary handle.

The

auxiliary handle ensures reliable guiding of
the power tool.

Before putting into operation, check the
power connection and the power plug for
damage.
Recommendation: The tool should always be
supplied with power via a ground fault circuit
interrupter (GFCI) with a rated current of
30 mA or less.

Handling hazardous dusts.

When working with power
tools, such as when grinding,

sanding, polishing, sawing or for other work
procedures where material is removed, dusts
develop that are both hazardous to one’s
health and can spontaneously combust or be
explosive.

Contact with or inhaling some dust types can
trigger allergic reactions to the operator or
bystanders and/or lead to respiratory infec-
tions, cancer, birth defects or other reproduc-
tive harm.

Examples of such materials which contain
chemicals that can produce hazardous dusts,
are:

–

Asbestos and materials containing asbes-
tos;

–

Lead-containing coatings, some wood
types such as beech and oak;

–

Minerals and metal;

–

Silicate particles from bricks, concrete and
other materials containing stone;

–

Solvent from solvent-containing paint/
varnish;

–

Arsenic, chromium and other wood pre-
servatives;

–

Materials for pesticide treatment on boat
and ship hulls;

–

Stainless steel dust, metal dust and non-
ferrous metal dust;

To minimize the unwanted intake of these
materials:

–

Use dust extraction matched appropriately
for the developing dust.

–

Use personal protective equipment, such
as a P2 filter-class dust protection mask.

–

Provide for good ventilation of the work-
place.

The risk from inhaling dusts depends on how
often these materials are worked. Materials
containing asbestos may only be worked on
by specialists.

Wood and light-metal dust can
cause spontaneous combus-
tion or explosions.

Hot mixtures of sanding dust and paint/var-
nish remainders or other chemical materials
in the filter bag or the vac filter can self-ignite
under unfavorable conditions, such as spark-
ing from sanding metal, continuous sunlight
or high ambient temperatures. To prevent
this:

–

Avoid overheating the material being
sanded and the power tool.

–

Empty the dust collector/container in time.

–

Observe the material manufacturer’s
working instructions.

–

Observe the relevant regulations in your
country for the materials being worked.

WARNING

CAUTION

OBJ_BUCH-0000000224-001.book Page 8 Tuesday, July 28, 2015 11:31 AM