Fein ASge636, Handbook

Page: 14 / 62

14
en
Original Instructions Tapper.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
WARNING
Character Unit of measure,
international Unit of measure,
national Explanation
n
0
/min rpm No-load speed (Anti-clockwise)
n
1R
/min rpm Speed, full load (Clockwise)
n
1L
/min rpm Speed, full load (Anti-clockwise)
P
1
W W Power input
P
2
W W Output
M… mm mm Size of metric thread
Ø mm mm Diameter of a round part
d
1
mm mm Thread size of drilling shaft
d
2
mm mm Collar diameter
kg kg Weight according to EPTA-Procedure 01/2003
mm mm Tap
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K… Uncertainty
m/s
2
m/s
2
Vibration emission value (triax vector sum) deter-
mined according to EN 60745
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measure from the inter-
national system of units
SI
.
3 41 01 132 06 0.book Seite 14 Mittwoch, 13. Oktober 2010 12:57 12