9
DIRECTION OF SAWING
Align saw blade to the right of the operator.
OVERLOAD PROTECTION
Under extreme overload, the current consumption
may considerably exceed the permissible nominal
value. In this case, overload protection prevents
the motor from burning out. The saw has a reset
button (A) that will restart the motor after it shuts
off due to extreme overload, if the motor stops during operation, turn the ON/OFF switch to the
OFF position. Unplug the saw from its power source. Wait about three minutes for the motor
to cool down. Push in on the reset button and turn the switch to the on position. Refer to Fig.19
THE GUIDE RULER
The guide ruler can be used to cut a straight sawing
line along the workpiece and can be affixed at the
front of base with the wing nut. The guide ruler (C)
can be used on the right side of the blade only,
shown in Fig.20. Using the guide provides accurate
cuts compared to free-
hand cutting. Locate the guide
into the mounting slots (A) at the front of the baseplate
and tighten the wing screw (B) to lock it at the desired
cut width. Refer to Fig.20
C
A
B
Fig.20
Fig.19
A