![background image](http://html1.mh-extra.com/html/feig-electronic/tst-fu3e/tst-fu3e_start-up_548930006.webp)
TST
Startup
FU3E
FEIG ELECTRONIC GmbH
Page 6 of 29
FU3E_Inbetriebnahme_7_GB.doc
3
Installing the Controller
WARNING
The system must be switched off while
installing the controller
ATTENTION
•
Before installing, check the controller for
any transport or other damage. Damage
inside the controller may under some
conditions result in significant following
damage to the controller including hazards
to the user.
Min. 100mm
Min. 100mm
50°C
-10°C
Fig. 1: Installing the controller
•
Do not touch any electronic parts,
especially parts of the processor circuit.
Electronic components can be damaged or
destroyed by electrostatic discharge.
•
Before opening the housing cover, be sure
that no drilling ships on the cover can fall
into the housing.
•
You have to make sure that the housing is
installed without tension.
•
Not used cable entries must be closed in
order to get IP54.
•
The cable entries are not allowed to have
mech. stress.
Fig. 2: Hole pattern