Feig Electronic OBID i-scan ID ISC.ANT.MUX, Manual

Page: 24 / 27

OBID i-scan
®
Manual Communication FU
FEIG ELECTRONIC GmbH Page 24 of 27 H30701-3e-ID-B
3.2.10. [0xCA]: Set Address
This protocol is used to set the address of the antenna tuner.
Host
→
Tuner
CMD Data
[0xCA]
Tuner-Adr
1
ADDRESS
0x02 8 bits 0xFE 8 bits 8 bits
Host
←
Tuner
Data
STATUS
2
0x00 8 bits
ADDRESS: 0x01 .. 0x04 are available DAT-addresses
3.2.11. [0xCB]: Set Mode
This protocol is used to activate special modes on the antenna tuner.
Host
→
Tuner
CMD Data
[0xCB]
Tuner-Adr
3
MODE
0x02 8 bits 0xFE 8 bits 8 bits
Host
←
Tuner
Data
STATUS
4
0x00 8 bits
MODE: 0x01: Automatic Address Setting (reset to the current Mode after a CPU-
Reset [0xC1])
0x02: Sensitive Tuning Mode (stored in E
2
PROM)
0x03: Approximate Tuning Mode (stored in E
2
PROM)
0x04: Extended Tuning Mode (all possible capacities are measured - takes
up to 6 min! Reset to the current Mode after a CPU-Reset [0xC1])
1
see 3.1. System Description of the Antenna Tuner
2
see APPENDIX A: Index STATUS
3
see 3.1. System Description of the Antenna Tuner
4
see APPENDIX A: Index STATUS