IDENTIFICATION
ID ISC.LRU3000 / 3500
Page 7 of 8
Hiermit erklärt FEIG ELECTRONIC GmbH, dass der
Funkanlagentyp ID ISC.LRU3000/3500 der Richtlinie
2014/53/EU entspricht.
Der vollständige Text der EU-Konformitätserklärung
ist unter der folgenden Internetadresse verfügbar:
http://www.feig.de/de/downloads-
support/konformitaetserklaerungen.html
Performance Classification gemäß ETSI EN 301 489:
Class 2
Hereby, FEIG ELECTRONIC GmbH declares that
the radio equipment type ID ISC.LRU3000/3500 is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is
available at the following internet address:
http://www.feig.de/en/downloads-
support/declarations-of-conformity.html
Performance Classification according to ETSI EN
301 489: Class 2
Notice for USA and Canada
FCC ID: PJMLRU3000, IC: 6633A-LRU3000
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communications Commission
Rules permitting the operation of this device.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Warning: Changes or modification made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
To comply with FCC Part 15 Rules in the United States / with IC Radio Standards in Canada, the system
must be professionally installed to ensure compliance with the Part 15 certification / IC certification. It is the
responsibility of the operator and professional installer to ensure that only certified systems are deployed in
the United States / Canada.
This radio transmitter (identify the device by certification number, or model number if Category II) has been
approved by Industry Canada to operate with the antenna types listed below with maximum permission gain
and required antenna impedance for each antenna type indicated. Antenna types, not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de modèle
s’il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner avec les types
d’antenne ’énoncé ci-dessus et ayant un gain admissible maximal et l’impédance requise pour chaque type
d’antenne. Les types d’antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal
indiqué, sont strictement interdits pour l’exploitation de l’émetteur
Following antennas are approved by FCC according FCC Part 15 and IC Canada according RS210
ID ISC.ANT.U170/170-FCC (4.0 dBic)
ID ISC.ANT.U250/250-FCC (9.0 dBic)
ID ISC.ANT.U270/270-FCC (9.0 dBic)
ID ISC.ANT.U600/270-FCC (10,5 dBic)
