OBID i-scan
®
Application Note
ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH
Page 29 of 31
N71200-0-de-ID-B.doc
E N G L I S H
4.3.5. Tuning the Gate Antenna
Before tuning the gate antenna, you must quit the ISOStart software. Then the gate can be tuned
as follows:
Step
Action
Note
1
Start “DATuningTool” software
2
Select “Detect Reader...”.
In the „Detect Reader“ window
select the interface (COM-Port
1, BusAdr. 0) and then press
“Detect”.
3
Use „Settings“ to enter the
configuration:
Single Mode,
Number of Antennas
3 to 5
Click on “with Multiplexer“
Number of Tuning Iterations
3
4
Activate „Start Tuning“ and
wait until the tuning process is
finished.
...
...
5
The tuning status is displayed
after each tuning process.
After successful tuning all
antennas are shown in green.
A red marked antenna shows
a not successful tuning.
6
If this does not succeed on
the first try, start the process
again by clicking on „Start
Tuning“
After successful tuning, close the DATuningTool.
3 to 5