IDENTIFICATION
ID HyWEAR compact
10 Operation
Page 19 of 41
10 Operation
Operation
The instructions given in this user guide are based on the settings defined ex works. It is possible to
configure own settings, therefore see chapter 10.5 Configuration on page 23.
10.1 Charging the Battery
Before initial operation, the battery should be fully charged. This can be done either via the supplied USB-C
cable or via the ID HyWEAR Charging Station. As long as the battery is charging via USB-C, the charging
status LED lights up yellow. If the ID HyWEAR compact is charged when switched off, the blue LED starts
flashing simultaneously to signal the connection establishment. If the battery is fully charged, the charging
status LED goes out. If the battery is completely discharged, the yellow LED flashes every 3 seconds for 0.2
seconds.
NOTE:
The battery temperature must not exceed 45 °C (113 °F). Therefore, charge batteries only in the
temperature range from 0 °C to 40 °C (32 °F to 104 °F).
10.1.1 Charging via ID HyWEAR Charging Station
The high quality ID HyWEAR Charging Station is part of the accessories of the ID HyWEAR compact and is
supplied with it. Up to four batteries can be charged simultaneously. The charging status is indicated by a
status LED. The blue LED indicates that the ID HyWEAR Charging Station is supplied with power. Thanks to
the latest technology, overcharging of the batteries is impossible. Due to the rubberized underside of the
charging station, it can also be placed on smooth surfaces without slipping. It is also possible to mount the
charging station on a wall.
To charge the battery:
1. Press the clip on the lower side of the ID HyWEAR compact to release the battery.
2. Carefully slide the battery out of the guide rail.
3. Place the battery in the charging slot with the contacts facing down.
4. Ensure the battery is placed properly.
5. Ensure the ID HyWEAR Charging Station is plugged in. To connect the power plug to the ID HyWEAR
Charging Station, it is necessary to bend the cable slightly (do not kink!).
6. To remove the battery, pull the battery release clip.
Complete charging takes approx. 2 hours. Use only the charging station provided by FEIG ELECTRONIC.
