IDENTIFICATION
ID HyWEAR compact
10 Operation
Page 23 of 41
10.4 Scanning
To scan a barcode or an RFID tag, aim at the target and press the trigger button. You can configure the scan
engine via “HyWEAR Config Tool”.
After pressing the trigger button, the ID HyWEAR compact tries to read a barcode or an RFID tag for 3
seconds. During this time, the yellow LED is lighting up constantly. If the scan was successful, the green
LED lights up. In case of an unsuccessful scan, the red LED lights up.
10.5 Configuration
To configure the ID HyWEAR compact the software “HyWEAR Config Tool” is required, which can be
obtained from the FEIG ELECTRONIC download area. Please use the login data, which you can find in the
manual. For the different configuration parameters, see chapter 11 Configuration Parameters on page 24.
10.6 Powering Down the ID HyWEAR compact
The ID HyWEAR compact automatically powers down after the parameter AUTO-POWER-OFF (default
setting: 600 s) has been lapsed and no button was pressed or if a connection could not be made within 60 s.
To manually power down the device, press either the left or the right button for 5 seconds and wait until all 4
LEDs light up, then release the button. The LEDs go out after 4 seconds and you hear a beep, indicating that
the ID HyWEAR compact powers down.
10.7 Reset to Default
10.7.1 Controller Reset
To perform a controller reset, press and hold the left button and the right button for 5 seconds. Fast repeated
flashing of the 4 LEDs and a beep at the end signal the start of the controller reset.
10.7.2 Complete Parameter Reset
To perform a complete parameter reset, press and hold the trigger button, left button and right button for 5
seconds within the first 30 seconds after powering up the ID HyWEAR compact. The start of the complete
parameter reset is signaled by the flashing of the 4 LEDs in the sequence blue-red-yellow-green (twice) and
a beep at the end.
NOTE:
After a complete parameter reset all user configured parameters will be lost.
