ORIGINAL INSTRUCTIONS
17
6. MAINTENANCE AND STORAGE
1. Maintenance
Before any maintenance work, the machine must be switched off and completely
cooled.
Perform the maintenance work according to the instructions below and perform
them regularly. A clean, well-maintained machine increases its standard of living
and efficiency. On the contrary, a machine maintained can cause damage,
accidents and render the tool inoperable in the short term.
Any other maintenance, modification or repair work must be carried out by a
qualified professional.
Do not immerse the tool in water or any other liquid.
a. After each use
-
Clean the engine block louvers with a blower.
-
Check the chain brake if it is working properly.
-
Clean the plastic parts before wiping with a damp cloth.
-
Check the use of the chain guide
-
Check the auto lubrication circuit if it is obstructed or not.
-
Check sprocket condition
-
Clean the cylinder fins with a compressor
b. Cleaning the air filter
Use a compressor to blow dust and chips.
To clean the filter foam: open the air filter, remove the foam. Clean this foam with
gasoline, wring out and dry. Replace the foam in the air filter and reassemble as
described in the diagram.
After 10 uses, replace the foam with a new one.
c. Cleaning the oil filter and fuel filter
Clean these items regularly. Remove them from the tanks using clamps. Clean them
with gasoline and then put them back in place afterwards
d. Guide bar
Cleaning: Remove bar guide to remove dirt from grooves and oil inlet.
Regularly grease the pinion.