Feider Machines FRX600, Instruction Manual

Page: 43 / 121

EN
e) Do not attach a saw chain, woodcarving blade, segmented diamond
wheel with a peripheral gap greater than 10 mm or toothed saw blade.
Such blades create frequent kickback and loss of control.
f) Do not “jam” the wheel or apply excessive pressure. Do not attempt
to make an excessive depth of cut.
Overstressing the wheel increases the
loading and susceptibility to twisting or binding of the wheel in the cut
and the possibility of kickback or wheel breakage.
g) When wheel is binding or when interrupting a cut for any reason,
switch off the power tool and hold the power tool motionless until the
wheel comes to a complete stop. Never attempt to remove the wheel
from the cut while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the cause of wheel
binding.
h) Do not restart the cutting operation in the workpiece. Let the wheel
reach full speed and carefully re-enter the cut. The wheel may bind, walk
up or kickback if the power tool is restarted in the workpiece.
i) Support panels or any oversized workpiece to minimize the risk of
wheel pinching and kickback.
Large workpieces tend to sag under their
own weight. Supports must be placed under the workpiece near the line
of cut and near the edge of the workpiece on both sides of the wheel.
j) Use extra caution when making a “pocket cut” into existing walls or
other blind areas.
The protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.