Information:
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another;
The declared vibration total value may also be used in a preliminary assessment
of exposure.
Warning:
the vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used;
it is necessary to identify safety measures to protect the operator that are based
on an estimation of exposure in the actual conditions of use (taking account of all
parts of the operating cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time).
Wear hearing protection.
ASSEMBLY & OPERATION
Always make sure the power tool is isolated from the power supply before
fitting any attachment
Auxiliary handle
The position of the front handle can be changed, according the work to do and the position of
the operator. Unscrew it (but it cannot be removable) and change its position. Screw the
handle to fix it in place.
Assembly of bit/chisel SDS
The tool must be switched off and unplugged when assembly a bit on the tool.
Install the correct chisel or bit according to the intended operation.
- Pull and hold the chuck rearward.
- Insert the bit/chisel in the hole on the front cover.
- Adjust the groove position while turning the bit, and furthermore insert it until it hits the end of
the hole.
- Release the chuck. Pull the tool to make sure that it is locked completely.
WARNING
!
07
