Sit the plastic cover on the wing to work out where to cut it. I screwed the pieces
to the wing so if you needed access to the servo you could remove it easily.
After the flying surfaces are finished I bolted all the rockets and tanks on with the
hardware provided. I did not add the tanks and rockets until after I did the test
flight. This was to ensure that the weight and drag of the model wasn’t too great.
The wing tanks mount with a 3mm socket head bolt on one end. You may need to
file the hole so the bolt slides easily. The other end has a 3mm socket head that
goes through the entire piece and has a nyloc nut to retain it. Finish the wings
before moving on to the fuselage to make the airline and servo extension leads
easier to run.
