11
3.3 Manual channel search and Settings.
Confirm that the transmitter has entered a normal working
condition.Turn on power of the monitor to the working state.
Press “
MODE
” and select “
RF1
”, “
RF1 BAND:X CH:X
” will display on
the upper left corner of the screen, then press “
＜
/BAND1
” to switch
RF1 channel BAND A/B/C/D, and press “
＞
/CH1
” to select RF1
CH1~8. If the transmitter works, frequency of receiver and transmitter
are in agreement, the receiver will receive the signal sent from the
transmitter and displayed on the monitor.
Press “
MODE
” and select “
RF2
”, “
RF2 BAND:X CH:X
” will display on
the upper right corner of the screen, then press “
∨
/BAND2
” to switch
RF2 channel BAND A/B/C/D, and press “
∧
/CH2
” to select RF2
CH1~8 . If the transmitter works, frequency of receiver and
transmitter are in agreement, the receiver will receive the signal sent
from the transmitter and displayed on the monitor.
Note: The effect of receiving and the distance has a great
relationship with the reception power of the transmitter and the
receiver venues. If the reception is poor, the antenna can be
replaced with three leaves, four leaves antenna or panel antenna.
Please note that the antenna and receiving should be same
frequency when replace the antennas.
