FeelTech
6
SGP3000 Series Users Manual
1
、
Press
【
MENU
】
button under sweep function interface to enter beginning frequency setting
interface.
F=00021.00000kHz
SWEEP BEGIN FREQ
Use
【
】、【
】
、
【
】、【
】
to change beginning frequency value.
Use
【
OK
】
to save current beginning frequency value.
2
、
Press
【
MENU
】
button under beginning frequency setting interface to enter end frequency
setting interface.
F=00021.00000kHz
SWEEP END FREQ
Use
【
】、【
】
、
【
】、【
】
to change end frequency value.
Use
【
OK
】
to save current end frequency value.
3
、
Press
【
MENU
】
button under end frequency setting interface to enter sweep time setting
interface.
F=00021.00000kHz
*FUNC:TIME=001S
Use
【
】、【
】
、
【
】、【
】
to set sweep time.
Use
【
OK
】
to save current sweep time value.
Note: The step value of frequency sweep is affected by sweep time. It is updated every 10 ms.
The step value is calculated by the instrument itself.
9
、
Load/Save function
Press
【
SYS
】
button to enter Save/Load function. This function allow the user to save to or load
from M0~M30 for frequency, amplitude, offset, duty cycle, waveform, phase and so on.
Press
【
】、【
】
to select from M0~M30. Then press
【
OK
】
button. The screen will
display “OK” and the parameters have been loaded successfully.
F=00021.00000kHz
*FUNC:LOAD=00 OK
If it displays
“
Non”, it means no data saved at this position
。
F=00021.00000kHz
*FUNC:LOAD=00 Non
1
、
Press
【
SYS
】
button under loading interface to enter saving interface. The current frequency,
amplitude, offset, duty cycle, waveform and phase can be saved. This instrument has 31
positions for saving.
Press
【
】、【
】
to select the position for saving
（
M0~M30
）。
Press
【
OK
】
button,
the screen display “M” and saving completed.
Parameters of M0 are the default parameters at start-up.
F=00021.00000kHz
*SAVE P_ON FREQ
Position M1~M30 is planed by user. Interface as follows:
