![FeelElec FY8300S Series User Manual Download Page 47](http://html1.mh-extra.com/html/feelelec/fy8300s-series/fy8300s-series_user-manual_3823925047.webp)
FeelElec
FY8300 Series User
’
s Manual
45
Troubleshooting
This chapter lists the commonly encountered failures of FY8300S and their
solutions.
When you encounter these problems, please solve them following the
corresponding steps below. If the problem remains still, please contact
FeelElec
and provide the device information (Press
SYS
to get it).
Failure Phenomena
Solutions
The
screen
of
the
generator is still dark (no
display) after switch on.
1) Check whether the power is correctly connected.
2) Check whether the power switch has been pulled
in place.
3) Restart the instrument after finishing the above
inspections.
4) If it still does not work correctly, please contact
FeelElec
.
CH2,CH3 is locked.
1) Check that the signal generator is operating in
synchronous state. Press the
SYNC
button to enter
the synchronization settings interface to cancel all
synchronization parameters.
2) If the problem is still, please restart the generator.
Set correctly,
but no waveform output
1) Check whether the BNC cable is connected
tightly with CH1, CH2 or CH3 connector.
2) Check whether the BNC cable has internal
damage.
3) Check whether the BNC cable is connected
tightly with the test instrument.
4) Check whether the indicators of CH1, CH2 or
CH3 is turned on. If not press corresponding button
to turn it on.
5) If the problem is still, please contact
FeelElec
.