7
®
All drawings are for illustrative purposes only.
INSTALLATION, OPERATION, & MAINTENANCE
ChromaSteam
®
X
INSTALLER
Installing the Junction Box
Functions of the Junction Box:
1.
Allows precisely location of the ChromaSteamX fixture within
the steam room ceiling.
2.
Provides a secure and easily identifiable holder for the control
cable while the steam room is being constructed.
3.
Works with the ChromaSteamX fixture’s retention springs to
prevent the fixture from falling and injuring a person in the
enclosure.
Locating the Fixture:
1.
Locate the fixture for optimal lighting within the enclosure.
2.
ChromaSteamX is for mood lighting only. Not to be used as a
primary lighting source.
3.
Do not locate the fixture in direct shower spray, near direct
steam emission, or in any location where a lighting fixture may
be damaged.
To Install the Junction Box:
1.
Remove the two screws from the interior clips of the junction
box, and hand-screw them into the wings of the junction box
(Figure 7)
.
2.
Remove one of the four knockouts from the junction box
(Figure 7)
. the resulting hole will allow routing of the 30-foot
LED power cable.
3.
Locate the two tabs on the junction box, and line them up
against a ceiling joist. The tabs locate the junction box slightly
raised from the joist. Screw the two screws into the ceiling joist
to secure the junction box
(Figure 8)
.
4.
Route one end of the 30-foot LED power cable through the
knockout into the junction box, and fasten it to one of the
interior clips to hold it in place
(Figure 9)
. Note that both ends
of the 30-foot LED power cable are the same.
IMPORTANT NOTE:
Contact MrSteam to purchase an optional
60-foot cable (Part No. 104268-60).
• Be careful not to strain, staple, pinch, or otherwise damage the
cable.
• Route cable as required to permit replacement.
• Cable should be run in dedicated conduit to facilitate
installation, service, and replacement.
• To prevent damage to the cable, do not route cable close to hot
water, steam piping, or any heat source.
5.
After the junction box is completely installed, ensure that you
create an opening in the steam room ceiling that aligns with
the junction box
(Figure 10)
.
• Installation to be performed by a
qualified and licensed electrician.
•
Shock Hazard.
Ensure that power is
turned off during installation. Turn off
power at breaker panel.
Failure to use the junction box with
correctly installed retention springs
may result in the ChromaSteamX
fixture falling and causing injury.
• To prevent leaks, do not install the
ChromaSteamX fixture where direct
contact with steam emission or water
spray could occur.
• The ChromaSteamX fixture is not
intended to be installed underwater.
To prevent leaks, do not install the
ChromaSteamX fixture in a location
where it could become submerged.
• The ChromaSteamX fixture is not
rated for insulation contact.
Insulation must be a minimum of 3”
away from all sides of the
ChromaSteamX fixture assembly to
prevent damage to the fixture.
