N
O
P
R
S
Schedule - Blue LED, located inside the Schedule (G) button, indicates a schedule is
loaded onto the device and enabled.
Audio - Blue LED, located inside the Audio (H) button, indicates an audio message is
playing (blinking) or being recorded (on solid).
Speaker - When it's time for your Feed and Go device to feed or call your pet over,
your personalized message will come out of the speaker.
Microphone - When you want to set your personalized message that your pet will
hear every time your device is activated, this is where you speak your message in to.
Your message can be up to 6 seconds long.
Opening buttons – located at the front of the device on the bottom left and right side.
Press them both at the same time to open the feeder when you want to place food into
the tray or when you want to remove the tray to clean it.
5
H
I
J
Audio - This button (on the right side) will play your recorded voice message when
pushed. Don't like your recorded message? Press and hold to record a new one!
Power - Blue LED, next to the power jack, indicates the device is powered.
Network - Blue LED, next to the reset hole. Used for indicating if the device is
connected to a network (on solid), in WPS mode (blinking quickly) or in Access Point
mode (blinking slowly).
K
L
M
Cloud - Blue LED, next to the WPS button, indicates the device is connected to the
Feed and Go cloud service.
Video - Blue LED, on top of the feeder next to the camera lens, indicates video is
active.
Feed – Blue LED, located inside the Feed (F) button. A solid blue light indicates the
motor is active. A blinking light indicates a possible jam. Clear a jam by pressing the
opening buttons (P) and removing the feed tray. Make sure any excess food that's getting
stuck and stopping the motor from turning is removed before returning the tray. Make
sure that when you do put the tray back in, it's in the right place for your pet's next feed.
