2.
Press and hold the WPS button (E) on your feeder. The Network LED (J) and Cloud
LED (K) will flash quickly and then the Network LED (J) will flash slowly for a few seconds
before it starts flashing quicker.
3.
When the Network LED (J) starts flashing quicker then let go of the WPS button.
4.
Within 1-2 minutes the Network LED (J) and the Cloud LED (K) will be solid blue.
9
1.
Press and hold the WPS button on your internet router for a few seconds. It may start
flashing to let you know it's searching for new devices.
1.
Remove the power cable from the back of your feeder for two minutes before reconnecting.
3.
Now follow steps 2, 3 and 4 above.
2.
Insert a pin into the Reset hole (D) and hold it down for a few seconds until the Feed LED
(M) and the Schedule LED (N) flash quickly. This will reset your feeder to factory settings.
Now the Network LED (J) should be flashing slowly.
5.
Your Feed and Go device should now be connected to your wireless internet router.
You can go ahead now to the Final Setup section on page 12.
BACK VIEW
E
J
K
If this method didn't work for you then try the following:
If there is still a problem setting up this way then please go ahead to page 10 and follow the
instructions for Wi-Fi setup via Access Point.
