- 22 -
MAINTENANCE
Ceiling LED Replacement (Cases Manufactured after 08/01/18)
1.
Turn power switch on rear of case to “off.”
2.
Disconnect light cord barrel plug from receptacle in LED by pulling barrel plug straight out.
3.
The LED is attached to clips mounted to the ceiling. Disengage the LED from the clips.
4.
Attach the new LED to the clips on the ceiling. Be sure that LED is centered about clips.
Shelf LED Replacement (Cases Manufactured after 08/01/18)
1.
Turn power switch on rear of case to “off.”
2.
Disconnect light cord barrel plug from receptacle in LED by pulling barrel plug straight out.
3.
The LED is adhered to the front shelf support with double-sided tape. It may be necessary to use a
razor blade to detach the LED from the top light housing. NOTE: TAKE CARE NOT TO
DAMAGE THE FINISH ON THE FRONT SHELF SUPPORT.
4.
Remove the remaining double-sided tape from the Front Shelf Support.
5.
Apply a new layer of double sided tape to the new LED and adhere to the front shelf support.
Locate new LED by centering between (2) .09 dia holes on the front shelf support.
PERIODIC MAINTENANCE
Cleaning Condenser Coil (All Self Contained Refrigerated Models)
NOTICE:
Condenser coil must be cleaned a minimum of twice per month to insure
proper refrigeration performance and prevent compressor failure. In
some environments, it may be necessary to clean more frequently.
FAILURE TO CLEAN CONDENSER COIL WILL VOID
COMPRESSOR WARRANTY.
1.
Disconnect power to the unit.
2.
Remove the back base panel located on the back bottom of unit by removing the (6) front panel
retaining screws.
3.
Carefully vacuum the front surface of condenser coil. Take care not to bend coil fins with vacuum
cleaner nozzle.
4.
Reinstall back panel and retaining screws.
VACUUM FRONT
SURFACE OF
CONDENSER COIL
(6) REAR BASE
PANEL SCREWS
