OPERATING INSTRUCTIONS
Initial Start-Up
After all the checks outlined in the installation section of this manual have been made,
the case is ready to be put into service.
Doors
Clean the door track frequently for easy door operation. A very light film of lubricant,
such as PAM, will help the doors slide easily.
The entire door track assembly may be removed if desired by tilting the top back and
lifting the entire frame out.
The display case is intended to be operated with the rear doors in place. However,
during peak service periods, the doors may be removed for ease of serving out of case.
DO NOT keep doors off unit for long periods of time. Temperature display may not read
accurately with doors off of case. Disregard this temperature reading if doors have
been off unit for extended periods.
Light Replacement
Light bulbs are removed by unscrewing counter clockwise. Install bulbs by screwing in
clockwise. Do not over tighten.
When replacing lights, use direct equivalents to the original bulbs.
Placing Product into Case
Do not block the slots along the front or rear of the case display floor.
CASE SHOULD BE STOCKED WITH PRE-CHILLED PRODUCT ONLY.
All well cavities must be completely covered with food pans (not included) for proper
operation of case. A variety of sizes of pans can be used from 2” to 6” in depth.
Model
# of Well Cavities
SQ3HD
2
SQ4HD
3
SQ6HD
5
SQ8HD
7
Always preheat the wells before placing product into case. Freshly cooked product
should not
be placed into case with a probed temperature of less than 170ºF.
The digital temperature display measures
air
temperature inside the case. This display
is an indication only. The most accurate method to confirm satisfactory temperatures is
to probe product inside the case.
Market Deli Heated Cases
Page 6
