Federal SNR48, Installation & Operation Instructions

Page: 6 / 44

Series ’9 0 Refrigerated Bakery Page 6
CAUTION:
Do not push against the curved glass, end glass, doors or door frames
when removing the case from the skid or moving the case. Case damage
or glass breakage could result.
This label is located on the back of the display case.
PRE-INSTALLATION PROCEDURES
Inspection for Shipping Damage
You are responsible for filing all freight claims with the delivering truck line. Inspect all
cartons and crates for damage as soon as they arrive. If damage is noted to shipping crates
or cartons or if a shortage is found, note this on the bill of lading (all copies) prior to
signing.
If damage is discovered when the case is uncrated, immediately call the delivering truck line
and follow up the call with a written report indicating concealed damage to your shipment.
Ask for immediate inspection of your concealed damage item. Crating material must be
retained to show the inspector from the truck line.
INSTALLATION INSTRUCTIONS
Locating the Display Case
The case should be located where it is not subjected to the direct rays of the sun, heating
ducts, grills, radiator, or ceiling fans, nor should it be located near open doors or main door
entrances. Also, avoid locations where there is excessive air movement or air disturbances.
The condenser inlet is located at the rear of the case. Do not block this inlet and do not
locate the air inlet near a source of heat.
Removing the case from Shipping Skid
Move the case as near as possible to the final location before removing it from the shipping
skid.
Remove the four (4) bolts that secure the case to the skid. Do not remove the shipping
brackets from the case. The brackets are intended to be used as hand grips for locating the
case.
Remove the brackets when the case is in the final location