Federal SNR48, Installation & Operation Instructions

Page: 15 / 44

Series ’9 0 Refrigerated Bakery Page 15
Light Replacement
The light fixtures use a spring-loaded socket on one end. To remove a light, push the bulb
toward the spring-loaded socket until the opposite end drops out of the socket.
The bulbs are furnished with plastic safety light shields. Make certain the light shields are
always in place to safeguard against bulb breakage.
When replacing lights, use direct equivalents to the original bulbs.
Placing Product into Case
Do not overhang the wire shelves with product or display pans. Overhanging the shelves
will block the refrigerated air flow and could cause product loss.
Do not block the slots along the front or rear of the case display floor.
CASE SHOULD BE STOCKED WITH PRE-CHILLED PRODUCT ONLY.
The display pans are removable for cleaning and can become dislodged in shipment. To
ensure proper air flow and performance of the case, make sure that the display pans are
positioned as shown. Check that the pans are installed properly before placing product on
the display pans.
Periodic Maintenance
Cleaning Condenser Coil
Disconnect power to the unit.
Remove the rear grill and vacuum the front surface of the condenser coil. This
should be done everyone to two months as necessary.