Federal FCC-4, Installation & Operation Instructions

Page: 7 / 17

Shelving
The case is equipped with three tiers of adjustable glass shelves. The deepest shelf is at the
bottom and the shallowest at the top. Each tier is supported by three (3) shelf brackets.
Turn the shelf light switch “off”.
Remove both rear doors from the track by lifting them upward until the bottom edge clears the
lower door track and then outward.
To install the bottom shelf, put a 14” shelf bracket in the end shelf standard even with or above
the bottom light socket and tighten the locking cam.
Then install a center shelf bracket in the center shelf standard and tighten the locking cam.
The center shelf bracket has no end hook and is shorter than the end brackets in order to clear
the shelf light housing.
Hang the shelf light assembly with the longest cord on the end shelf brackets.
Plug the shelf light cord in the light socket. Make certain the light cord is completely inserted
into the socket or arcing may result causing damage to the plug and socket.
Each shelf bracket gets two plastic supports with rubber pads. Put two single width supports
on each end shelf bracket. Put two double width supports on the center shelf bracket.
Repeat the steps for the middle and top shelves.
Put the glass shelves on the support pads as shown for each tier. If the shelf is not in the
proper position, it may disrupt air flow in the case and cause product loss.
Reinstall both rear doors.
Lights
Make certain that the light cord plugs are completely inserted into the sockets or arcing may
result causing damage to the plugs and sockets.
Cleaning
For initial setup, clean the case as outlined in the Weekly Cleaning Section.