Federal Signal Corporation
Informer Tone Alert Receiver Manual
2-2 Standard
Features
•
Available in 5 frequency bands from 33 MHz to 866 MHz
•
Long life rechargeable battery with built-in charger
•
Wide temperature operating range
•
Excellent RF sensitivity, and selectivity
•
Clean, low distortion of recovered audio
•
Loud +85dBA output at 10’
•
Signal to Noise based squelch circuit, does not open receiver in high radio
noise environments i.e., near computers etc.
•
Programmable RF, Single Tone, Two-Tone, DTMF, CTCSS, and CDCSS
(DPL) decoding
•
Re-programmable over RS232 port without removing IC chips
•
Volume control, monitor and reset buttons with diagnostic LEDs
2-3 Optional
Features
•
Programmable MSK decoder compatible with The Federal
Commander Digital System.
•
Programmable EAS decoder for decoding NOAA radio SAME code
alerts.
•
600-Ohm audio output and 2 SPDT relay outputs.
•
Windows 95/98® based programming software
•
IS2 and FB2 Strobe Light Accessories
Note: The MSK and EAS decoders are not available simultaneously in the same
unit. All other options can be used together.
2-2
GENERAL DESCRIPTION
