NOTE
For maximum coverage and effectiveness, the
light assembly should be mounted in a
horizontal orientation.
Installation can be accomplished using the
supplied bracket(s) and screws, adhesive pads, or
velcro strips. Determine the mounting position
appropriate for the installation, and then select the
applicable mounting method.
1.
Bracket(s)/Adhesive Pads or Velcro Strips.
WARNING
The surfaces to which the adhesive pads (or
velcro strips) are applied must be clean and
dry for proper adhesion. If necessary, use
isopropyl alcohol (rubbing alcohol) and water
to clean the mounting surfaces.
a.
Remove the release paper from one side
of the adhesive pad and apply the pad to the bracket
surface. Press the pad firmly against the bracket to
make sure that the pad adheres properly.
b.
Peel the release paper from the other side
of the pad and attach the bracket to the mounting
surface. Ensure that the assembly adheres firmly to
the mounting surface.
c.
Mounting on a flat non-metallic surface
can also be performed using the supplied velcro hook-
and-loop strips.
d.
Secure the light assembly to the mount-
ing bracket(s) using the 1/4" x 1/2" hex head Taptite
screws and lockwashers as shown in figure 1.
2.
Bracket(s)/Screws.
a.
See figure 1. Use the mounting bracket(s)
as a template and scribe mounting hole position
marks on the mounting surface.
CAUTION
Before drilling holes in ANY part of a vehicle,
be sure that both sides of the mounting
surface are clear of parts that could be dam-
aged; such as brake lines, fuel lines, electrical
wiring or other vital parts.
b.
Drill mounting holes at the previously
scribed position marks.
c.
Secure the mounting bracket(s) to the
mounting surface with the 1/4" x 5/8" hex head type
B screws.
290A3981
MOUNTING
SURFACE
DRILL REQUIRED
HOLES
BAIL
BRACKET (1)
SMLED2F ASSEMBLY
1/4" EXTERNAL TOOTH
LOCKWASHERS (2)
ADHESIVE
PAD
VELCRO
HOOK-AND-LOOP
STRIPS
1/4-20 x 1/2"
SCREWS,
TYPE TT, HEX
WSHR. HD. (2)
1/4 x 5/8"
SCREWS,
TYPE B, HEX
WSHR. HD. (2)
Figure 1.
MOUNTING PLATE
FLASHER P.C. BOARD
PLUG
ASSEMBLY
SMOOTH SIDE, GND
RIBBED SIDE, + 12 DC
290A3982
(+)
(
-
)
Figure 2.
-2-
d.
Secure the light assembly to the mount-
ing bracket(s) using the 1/4" x 1/2" hex head Taptite
screws and lockwashers as shown in figure 1.
E. ELECTRICAL.
The light assembly is supplied with a 10-foot
straight cable terminated with a cigar lighter plug. A
flasher PC board is installed at the factory. Addi-
tional wiring is not required. The flasher/light assem-
bly wiring diagram is shown in figure 2.
