Installation and Programming Instructions
4
Model 331105 SMC5 SignalMaster Controller
Installing the SignalMaster Lightbar
Install the light assembly as described in the instructions included with the SignalMaster. Route the cable to
the planned location of the controller.
Installing the Mounting Bracket for the Controller
The supplied mounting bracket allows the controller to be mounted in a variety of positions. To install the
mounting bracket:
CONTROLLER REQUIRES VENTILATION
—
This controller needs to radiate heat.
Do not install the unit in an area where it cannot dissipate heat into the air.
Do not mount the unit near a heater duct.
NOTE:
When selecting a mounting location for the control unit, it is necessary to keep in mind that some
SignalMaster models have cables which are 15-feet long. Plan wiring and cable routing before installation.
Nine-conductor extension cables are available if needed.
1.
Select a mounting location for the control unit that allows the vehicle and controls to be operated safely
at all times.
2.
Use the mounting bracket as a template and scribe two drill-position marks at the selected mounting
location. See Figure 1.
Figure 1
Bracket positions and hardware
290A5485B
BRACKET MAY BE REVERSED
AS SHOWN HERE TO MEET YOUR
MOUNTING REQUIREMENTS.
NOTE: ONLY
ONE
BRACKET
IS SUPPLIED.
1/4" LOCKWASHER,
EXT. TOOTH (2)
1/4-20 X 3/8" SCREW,
HEX WASH. HD (2)
SCREWS, THREAD FORM.,
USER SUPPLIED
