Federal Signal Corporation Informer15 I-IP15, Description, Specifications, Installation, Operation, And Service Manual

Page: 11 / 20

11
Specifications
Description, Specifications, Installation, Operation, and Service Manual
Federal Signal
www.fedsig.com
Table 3 Connectors and Jacks for the Controller Board
JP1 LED Lamp Test
Short pins 1 and 2 to turn on LED lamp
JP2 Inputs
1 – ISO-GND
2 – Input #1
3 – ISO-GND
4 – Input #2
5 – ISO-GND
6 – Input #3
7 – ISO-GND
8 – Input #4
JP3 LED Lamp Output
1 – GND
2 – Power, sw24 Vdc
JP4 Test mode
JP5 Factory Default
Short pins 1 and 2 to restore to factory defaults
JP6 Open Collector Output
1 – Output #1 Open Collector Output
2 – Output #1 +24 Vdc
JP8 Option1 Jumper
Short pins 1 and 2 for Standalone Option
JP9 Option2 Jumper
Short pins 1 and 2 for Option
JP11 Serial Port RJ25 6 conductor mod jack
JP12 Controller to Amplifier Interface
JP13 microSD FLASH card holder
M1 Communications from PoE board
Table 4 Connectors and Jacks for the Amplifier Board
JP1 Power Input from PoE board or the 24 Vdc power board
JP2 Balanced Audio Input – 10 or 25 V
RMS
in (Not used)
JP3 Audio Input Select Jumper (Not used with I-IP15 configuration.)
Jumper 1 and 2 = 25 V
RMS
input
Jumper 3 and 4 = 10 V
RMS
input
JP4 Amplifier to Controller Interface
Pin1 (-) Speaker output
Pin2 (+) Speaker output
VR1 Amplifier Gain (For max volume, turn clockwise.)