3
Model FHLP-TAH Headlight Flasher
Figure 1
Model FHLP-TAH flasher
Testing the Flasher
LIGHT HAZARD—To be an effective warning device, an emergency warning
system produces bright light that can be hazardous to your eyesight when
viewed at a close range. Do not stare directly into the lights at a close range
or permanent damage to your eyesight may occur.
To test the operation of the flasher:
1.
Verify that the flasher properly flashes the headlights when the control switch is turned ON.
2.
With flasher control switch ON, turn ON the high-beam switch and verify that both high-beam lights
turn on steady.
Table 3
Troubleshooting guide
Problem
Corrective Action
No operation
Verify that the flasher plugs are properly connected to the head lamps.
Headlights turn ON for a short
time then OFF for a couple of
seconds and repeats
The over-current shutdown of the flasher has detected too much
load on the flasher. Verify that a maximum of two 55 watt lamps are
connected to each output.
TO FORWARD LAMP
HARNESS PLUGS
