2561934A
REV. A 503
Printed in U.S.A.
INSTALLATION INSTRUCTIONS FOR
#350201-06 CUDA TRIOPTIC™ MOUNTING KIT
SAFETY MESSAGE TO INSTALLERS
WARNING
The lives of people depend on your proper
installation and servicing of Federal prod-
ucts. It is important to read, understand, and
follow all instructions shipped with the
products. In addition, listed below are some
other important safety instructions and
precautions you should follow:
Before Installation
Qualifications
•
To properly install this mounting kit, you
should have a good understanding of
automotive electrical procedures and
systems, along with the proficiency in the
installation and use of safety warning
equipment.
•
Never attempt to install aftermarket
equipment that connects to the vehicle
wiring, without reviewing a vehicle
wiring diagram – available from the
vehicle manufacturer. Insure that your
installation will not affect vehicle opera-
tion and safety functions or circuits.
During Installation
•
DO NOT install equipment or route
wiring in the deployment path of an air
bag.
•
Locate the light control so the VEHICLE
and CONTROL can be operated safely
under all driving conditions.
After Installation
•
Do not attempt to activate or deactivate
the light control while driving in a
hazardous situation.
•
You should frequently inspect the light
mounting assembly to ensure that it is
operating properly and that it is securely
attached to the vehicle.
•
This product is used for mounting high
intensity LED devices. To prevent
permanent eye damage, DO NOT stare
into the light beam at close range.
•
Test all vehicle functions, including the
light head operation, and vehicle safety
functions to ensure proper operation.
Ensure that the installation has not
affected vehicle operation or changed
any vehicle safety function or circuit.
•
After testing is complete, provide a copy
of these instructions to the instructional
staff and all operating personnel.
•
File these instructions in a safe place and
refer to them when maintaining and/or
reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage, serious
injury, or death to you or others.
A.
GENERAL.
The #350201-06 mounting kit is designed for use in
conjunction with the Federal Signal 351000 and 352000
series CudaTriOptic light heads. This kit is designed for
mounting the signal rear facing utilizing the child restraint
hooks located at the rear deck of the vehicle.
B.
UNPACKING.
After unpacking this mounting kit, carefully inspect for
damage that may have occurred during transit. If the kit is
damaged, file a claim immediately with the carrier, stating
the extent of damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying
them. Ensure that all parts in the following KIT CON-
TENTS LIST have been included.
C.
KIT CONTENTS LIST.
Qty.
Description
Part No.
1 1/4 –20 x 5/8 Hex Machine Screw
7000A311-10
1 1/4 Split Lockwasher
7074A016
1 Child Restraint Hook Bracket Assy.
8625221
1 Locking Plate
8625222
D.
INSTALLATION.
WARNING
This product is intended for supplemental
warning and for use in conjunction with an
approved primary warning light system.
When installing equipment inside air bag
equipped vehicles, the installer MUST ensure
that the equipment is installed ONLY in areas
recommended by the vehicle manufacturer.
Failure to observe this warning will reduce
the effectiveness of the air bag, damage the
air bag, or potentially damage or dislodge the
equipment, causing serious injury or death to
you or others.
1.
See figure 1. Orient the mounting bracket, locking
clip, lockwasher, and hex machine screw as shown with
